Bradley EXPRESS SS-2/AST/STD Installation Manual download pdf (Page 15)

Installation SS-2N/AST/STD, SS-2N/AST/WH

Bradley Corporation • 215-1498 Rev. F; ECM 11-08-011 10/24/11 15

Fill Soap Dispenser

The soap valve will dispense vegetable/coconut oil liquid soaps, synthetic detergents, viscous lotion soaps, and antiseptic solutions.

A 10-15% con cen tra tion is rec om mend ed for veg e ta ble or co co nut oil liquid soaps. Before filling, rinse out each soap tank with

hot water to remove packing dust. Shake water out thor ough ly and allow to dry. DO NOT OVERFILL!

Filler

Hole

#10Screw

Leaf Spring will engage when

soaptankispushedintoplace.

S65-291 (Gray)

includes:

S65-291A (Putty)

includes:

S65-291B (Coal)

includes:

GrayTankw/Valve

(S11-220)

PuttyTankw/Valve

(S11-220A)

CoalTankw/Valve

(S11-220B)

Leaf Spring

(S39-350)

Leaf Spring

(S39-350)

Leaf Spring

(S39-350)

Screw

(160-385)

Screw

(160-385)

Screw

(160-385)

Soap Tank Kits

Soap Valve Repair Kit (S65-258)

(includes Nut, Spring, Washer and Plunger)

SoapBlank

Gray(133-143)

Putty(133-143A)

Coal(133-143B)

Clean Soap Dispenser

Do not use abrasive cleansers to clean the soap tank. Abrasive cleaners can damage the surface.

Regular cleaning of the soap dispenser is recommended to ensure optimum performance and maximum service life. Cleaning the

soap dispenser monthly to remove soap residue, dirt, and other accumulations should become a regular part of your washroom

cleaning routine and general maintenance program.

Cleanexterior:Usewarmwaterandsoaptocleantheexteriorofthesoapdispenser.Drywithasoftcloth.

Cleaninterior:Inspecttheinteriorofthetankforresidueorcoagulationofsoap.Ifnecessary,cleanthetankaccordingtothe

followingprocedure:

1. Pouroutanyremainingsoapinthetank.

2. Fullthetankhalf-fullofhotwaterandshakethetanktodislodgethesoapresidue.

3. Empty the water from the container and repeat steps 1 and 2 until the soap container is clean.

If rinsing alone does not remove the soap residue, place a small chain (24 inches long) into the tank with hot water and

shake the container until the chain dislodges the residue. Then remove the chain and rinse out the tank.

Cleaninternalcomponents:Pumphotwaterthroughthesoapdispenseruntilacleanflowofwatercomesoutofthevalve.

To change soap, pour out all of the soap from the dispenser ans rinse with hot water several times until all residue is

removed. Pump the valve until clean water appears. Rinse the dispenser with ethyl alcohol; air dry before refilling.

1 2 ... 10 11 12 13 14 15

Comments to this Manuals

No comments

Bradley EXPRESS SS-2/AST/STD Installation Manual Page 15

Comments to this Manuals

Related products and manuals for Sanitary ware Bradley EXPRESS SS-2/AST/STD