Bradley EXPRESS SS-2/AST/STD Installation Manual download pdf (Page 7)

Express® Lavatory System SS-Series

Installation - Obsolete SS-2/AST/STD, SS-2/AST/JUV

Bradley Corporation • 215-1244 Rev. D; EN 08-805 4/24/08

Installation Instructions continue . . .

Installation Instructions continued . . .

Step 2: Mounting frame to wall

1. Remove the eight Torx-head screws

securing the panel to the frame, and

remove the panel (see Figure 3).

Note: Scuff panel does not need to be

removed.

2. Position the frame against the wall,

ensuring that it is level. If necessary,

insert shims under the frame until level.

Note: When mounted, the Standard and

Juvenile Height frames should rest on the

floor.

IMPORTANT: Anchoring the frame

to a wall that is not flat may

cause the frame to bend. If nec-

essary, install shims to compen-

sate for any wall distortion.

3. Ensure that the back of the frame is flat against the wall. If wall is not flat, insert shims

behind the frame to ensure that it will not bend when anchored.

4. Once you have positioned the frame such that it is level and resting on the floor and flat

against the wall or shimmed, use the 3/8" bolts and washers to mount the frame to the wall

(see Figure 4).

Figure 4

(4) 3/8" BOLT

AND WASHER

FRAME

Figure 3

PANEL

FRAME

(8) TORX-HEAD

SCREW

Figure 2

1-1/2" NPT DRAIN

STUB-OUT

1/2" NPT HOT AND

COLD SUPPLIES OR

TEMPERED SUPPLY

STUB-OUTS

SCUFF PANEL

(do not remove)

SCUFF PANEL

(do not remove)

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Comments to this Manuals

No comments

Bradley EXPRESS SS-2/AST/STD Installation Manual Page 7

Comments to this Manuals

Related products and manuals for Sanitary ware Bradley EXPRESS SS-2/AST/STD