Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
Installation Instructions TDB3104, WF3204
Bradley Corporation • 215-1470 Rev. H; EN 06-915
112/8/07
Installation Instructions continued . . .
Step 4a: Air Metering Valve assembly for A drain and O drain units without Tie Pipe option
1. Install hemmed end (not sharp end) of support tube with gasket onto bowl (see Figure 7).
2. Place sprayhead with 1/2" tubing onto support tube. Run the tubing down through the support
tube and connect to valve tube connector. Make sure the spray holes point away from the wall.
3. Place the upper tie bar (notched at both corners of each end) on top of sprayhead parallel to wall.
Connect the longer tie rod to the 4-1/4" tie rod using the coupling nut with hex head set screws.
Run the tie rod assembly down through upper tie bar (see Figure 7 inset) and secure from under-
neath the bowl using lower tie bar (no notches) and hex nut with socket head set screw.
SEMI-CIRC. BOWL
Comments to this Manuals