Bradley S19-921 Installation Guide download pdf (Page 5)

Installation S19-921

Bradley • 215-1546 Rev. N; ECN 14-05-017 7/29/2014

Step 3: Test eyewash unit

1. After completing installation, test the eyewash station for proper

operation by pulling down the tray. Check for proper water

flow and quickly close the tray. Visually inspect the eyewash

unit weekly for cleanliness and proper solution level (per ANSI

Standard Z358.1-2009). When the water level drops below the

15-minute fill line, the tank must be emptied and then refilled. To

refill the eyewash tank, follow the procedures outlined in Step 2

found on page 4.

2. Attach the eyewash inspection tag (supplied) to the eyewash unit.

This tag is to be used for weekly inspection documentation. Hook-

and-loop fasteners are provided to attach the tag to the unit.

3. If the eyewash unit is not working properly, remove it from the

hazard area and contact Bradley Corporation immediately.

Clamp

Latch

Cap

Pedestal

Pierce

Tank

Snorkel

Drain Hole

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Bradley S19-921 Installation Guide Page 5